How to Create a Beaded Bracelet with Large and Small Beads

You'll Need:

• Big diameter beads (8 or 9 mm);
• Small beads (4 mm);
• Czech beads of white colour;
• 2 special needles for beading;
• Nylon thread;
• Fastener.

Instructions

The thread is taken about 130 cm long. Weaving a bracelet with beads is done using two needles on a nylon thread.

Both ends of the thread are threaded into needles.

The thread is tightened. This should be done so that the bead into which the needle was inserted closely adjoins the large bead, and the threads should be parted up and down on the sides.

The thread tightens so that the weaving of the small beads fits snugly against the second large bead.

Then the needle located below should pass in the opposite direction through the last small bead on the upper thread.

Weave White Beads

At the next stage, take the tip of the thread, which enters the small bead. On it, we will weave a bracelet with white beads. You can attach the clasp at the last stage, using the second end for this.

Next, with a needle and thread, string five white beads, then enter into the third and fourth bead, counting from the edge of the bracelet.

Again, take five white beads. Insert the needle into the third and fourth from the edge of the bead, and pass the needle into a nearby bead.

Attaching a Clasp

To do this, pick up five white beads.

Output the needle through the last three white beads.

The finishing touch is the clasp.

To fix the thread, bring it through the beads and beads to the central part of the bracelet. You need to make a knot.