How to Make Satin Ribbon Flowers

You'll Need:

2 colors of satin ribbon 5 cm wide (green and red or pink);

Glue gun;

Needle;

Thread;

Scissors;

Lighter.

Instructions

At this stage, cut 12 cm long rectangles from the red ribbon. For one rose, approximately 25 such strips are required.

To make a petal, take one rectangle with the wrong side facing you.

Lower the upper right corner down to form a triangle from the corner. Then, take a needle with thread and starting from the corner, sweep along the lower edge to about the middle of the strip. Now lower the upper left corner and sweep away the rest of the tape. Pull it slightly to form a petal, and fasten it. Similarly, follow the instructions for the remaining petals.

Take one petal, put a little glue on its right edge, and wrap it, fixing it on the second end with glue too. This will be the middle of the flower. Now take the second petal, apply glue along its lower edge, and glue it to the bud. The third and all subsequent petals should be glued in the same way, with each subsequent half coming into the previous one.